Kaiyi — 12. ENGINE CONTROL SYSTEM

GROUP 12 ENGINE CONTROL SYSTEM 1. MCU and Engine ECM (Electronic Control Module) ECM(Engine control module) 1 2 LED 1 MCU 2 Bolt (M8) CN-51 CN-52 480F5MS10 G : green, R : red, Y : yellow 5-74 2. MCU ASSEMBLY 1)To match the pump absorption torque with the engine torque, MCU varies EPPR valve output pressure, which control pump discharge amount whenever feedbacked engine speed drops under the reference rpm of each mode set. 2)Three LED lamps on the MCU display as below.

1) 2) LED lamp Trouble Service G is turned ON N ormal - G and R are turned ON T rouble on MCU · Change the MCU G and Y are turned ON T c rouble on serial · Check if serial communication ommunication line lines between MCU and cluster are disconnected Three LED are turned OFF T rouble on MCU power ·Check if the input power wire (24 V, GND) of MCU is disconnected ·Check the fuse