2) CLUSTER CHECK PROCEDURE (1) Start key : ON ① a. Check monitor Buzzer sounding for 4 seconds with HYUNDAI logo on cluster. If the ESL mode is set to the enable, enter the password to start engine. ② After initialization of cluster, the operating screen is displayed on the LCD. Also, self diagnostic function is carried out. Engine rpm display : 0 rpm Engine coolant temperature gauge : White range Hydraulic oil temperature gauge : White range Fuel level gauge : White range a. b. c. d. ③ Indicating lamp state Power mode pilot lamp : E mode or U mode Work mode pilot lamp : General operation mode (bucket) Travel speed pilot lamp : Low (turtle) a. b. c. (2) Start of engine ① a. b. c. d. e.
Check machine condition RPM display indicates at present rpm Gauge and warning lamp : indicate at present condition. When normal condition : All warning lamp OFF Work mode selection : General work Power mode selection : E mode or U mode Travel speed pilot lamp : Low (turtle) ② When warming up operation Warming up pilot lamp : ON After engine started, engine speed increases to1000 rpm . Others same as above . a. b. ③ a. b. When abnormal condition The warning lamp lights up and the buzzer sounds. If BUZZER STOP switch is pressed, buzzer sound is canceled but the lamp warning lights up until normal condition.
The pop-up warning lamp moves to the original position and blink when the buzzer stop switch is pushed. Also the buzzer stops. 5-81