(12) Disassemble rotation group as follows : Put identification marks on nine pistons (121), showing their location in the plate (123) and the plate (123) as a unit from the cylinder. Separate the piston assembles from the plate. Handle carefully so as not to damage sliding face on the retainer (113) or shoes (122). 900L8SM25 (13) Remove friction plates (742) and separa- tor plates (743) from casing (301). Pay attention to the position of friction and separator plates. (14) Remove the snap ring (437) with a plier and then remove the front cover (304) and oil seal (491) from the casing (301). Pay attention to the position of friction and separator plates.
Be sure to warp the output spline of driving shaft (101) with a cover or plastic tape to protect a lip of oil seal. 900L8SM26 (15) Remove shaft assembly from casing (301) with hammering at the other shaft end. Be careful not to damage sliding face on the shaft. 900L8SM27 8-52