4) REASSEMBLING Cleanliness is a primary means of insuring satisfactory motor life, on either new or repaired units. Cleaning parts by using a solvent wash and air-drying is adequate, providing clean solvent is used. As with any precision equipment, the internal mechanism and related items must be kept free of foreign materials and chemicals. Protect all exposed sealing surfaces and open cavities from damage and foreign material. It is recommended that all oil seals and O-rings be replaced. Lightly lubricate all oil seals and O-rings with clean oil prior to assembly. Lubricate all sliding sections, bearings, and cylinders with clean oil prior to assembly.
Reassemble the motor, following the procedures described below. (1) Place the motor in a vertical position with bell housing face down. Be sure to fix the motor casing (301) before assembling. 900L8SM30 (2) Heat the inner race of the bearing (443) (444) to 110 (230 ) max and insert to the drive shaft. And then attach the spacer (106) and the snap rings (432) (433) to the driving shaft (101). Do not exceed temperature 110 (230 ). Be sure to assemble the bearing (443) According to the following direction. Be sure to erase the inner race of the bearing (443) (444) before assembling. Outer race Roller Inner race 900L8SM31 8-54