Kaiyi — 1. PUMP DEVICE

Low tilting angle (low flow) command preferential function As mentioned above, flow control and horsepower control tilting angle commands are transmitted to the feedback lever and spool via the large-hole sections (C & F) of levers 1 and 2. However, since sections C and F have the pins ( Ш 4) protruding from the large hole ( Ш 8), only the lever lessening the tilting angle contacts the pin (897) ; the hole ( Ш 8) in the lever of a larger tilting angle command is freed without contacting the pin (897). Such a mechanical selection method permits preference of the lower tilting angle command of the flow control and horsepower control.

③ ④ Adjustment of input horsepower Since the regulator is of total cumulative horsepower type, adjust the adjusting screws of both the front and rear pumps, when changing the horsepower set values. The pressure change values by adjustment are based on two pumps pressurized at the same time, and the values will be doubled when only one pump is loaded. Adjustment of outer spring Adjust it by loosening the hexagon nut (630) and by tightening (or loosening) the adjusting screw C (628). Tightening the screw shifts the control chart to the right and increases the input horse-power as shown in the figure.

Since turning the adjusting screw C by N turns changes the setting of the inner spring (626), return the adjusting stem QI (627) by N Ч A turns at first. (A=1.81) a. 625 626 630 628 802 627 Adjusting values are shown in table. 8007A2MP03 Delivery flow, Q ( Delivery pressure, (P1+P2) 2-17 Adjustment of outer spring eed Tightening Compens- Flow amount of ating control change adjusting starting amount screw (C) pressure (928) change amount in -1) (Turn) (kgf/cm2) (ℓ/min) mpens- Flow g control change tarting amount ressure hange mount kgf/cm2) (ℓ/min) 00 +1/4 +17.7 +14.2