3) REASSEMBLY The pieces that are subject to general wear and tear are the following: Gears Bearings All the seals - - - Replace the used or irregular parts respecting the following steps: Accurately remove dirt, and in particular properly clean the seals, bearings and locking rings seating. Lubricate the parts before connecting them. In the case of damaged gears, for example a planetary, do not proceed to replace the individual gear but the entire reduction assembly. When reconnecting a part always replace all the seals involved. Add some grease on the seats and on the new seals to make easier the reassembly. - - - - Assemble the bearing inner ring (21) in the gearbox housing (22).
(1) Place the equipment on the bearing outer ring (21). (2) 8007A8TR44 (3) By using a press and the stopper push the bearing outer ring (21) against the gearbox housing shoulder (22). 8007A8TR45 8-107 8007A8TR43 8007A8TR43