PACCAR PX-7 — Poly V-belt and Fan Drive Belt Installation

ENGINE MAINTENANCE - Maintenance Procedures Drive Belts Fan Belt Tensioner automatic belt tensioner's roller, as shown in the image. Maintenance checks and procedures for engine drive belts. Maintenance checks for fan belt tensioner. 2 Perform these maintenance procedures according to the Preventative Maintenance Schedule. 4. Rotate the flex-bar as shown in the diagram to relieve belt tension. 5. With the belt tensioner pressure relieved, remove the poly V-belt from the pulleys. NOTE Always fit the same type of belts as the ones replaced. 1. Check and correct fan belt tensioner.

Mounting bolt torque Tensioner maintains proper belt tension The tensioner can be temporarily blocked with a 0.16-0.2 in. (4-5 mm) thick pin (bore). This facilitates removal and installation of the poly V-belt. 6. After removing the belt, carefully allow the belt tensioner to spring back to the stop (if it had not been temporarily blocked). 7. Inspect the pulleys for damage, rust, and grease deposits. Clean or replace as necessary. Engine Belt Checks Maintenance check for engine drive belts. Perform these maintenance procedures according to the Preventative Maintenance Schedule. Poly V-belt and Fan Drive Belt Removal Engine belt replacement procedures for poly V-belt and fan drive belts. 1.

Inspect the engine drive belts for the following conditions: Perform these maintenance procedures according to the Preventative Maintenance Schedule. Condition, signs of wear/ deterioration Alignment 1. Disconnect the electrical ground wire from the battery. 2. Reach between the fan blades and remove the fan blade mounting bolts using a 9/16 in. socket to remove the mounting nuts. 3. Place a flex-bar with a 15 mm socket on the fastener securing the Poly V-belt and Fan Drive Belt Installation Procedure to install poly v-belt and fan drive engine belts. Follow the steps below to install the poly V- belt and fan drive belts: 68 Y53-1183-1E1 (04/16/18)