ENGINE MAINTENANCE - Engine Identification Battery box mounting bolt – torque 2. Check mount and leg for fractures, breaks or deformation. Replace as necessary. 3. Check for complete insertion of motor mount. Replace as necessary. the front timing gear cover (PX-9). The engine EPA label must not be changed unless approved by PACCAR. 2 Crankshaft - Vibration Damper PX-7 EPA Label Location Maintenance checks for the engine crankshaft. Perform these maintenance procedures according to the Preventative Maintenance Schedule. CAUTION DO NOT re-torque or reuse ex- isting flange head bolts. These bolts are factory set to the speci- fied torque.
If bolts are loose or damaged, they must be replaced with the new bolts. Failure to comply may result in equipment or property damage. 1. If equipped with a rubber-type crankshaft damper, perform the following checks of vibration damper: Inspect for cracks, nicks, leakage Check fastener torque Engine Mounting Bolts Engine Identification Maintenance guidelines for engine mounting bolts. Engine Identification The engine dataplate contains information specific to that engine. The engine serial number (ESN) and control parts list (CPL) provide information for service and ordering parts. Perform these maintenance procedures according to the Preventative Maintenance Schedule.
Check for the following: PX Engine EPA Label EPA label location and label information. The EPA label provides important details about the engine. This label is located on top of the engine valve cover (PX-7) or on 1. Inspect both mount and leg fasteners. Check for loose or broken bolts. Replace as necessary. 72 Y53-1183-1E1 (04/16/18) .oN tsylataC