. OPERATION DETAILED CONTROLS AND GAUGES CIRCUIT BREAKER NOTICE When resetting the circuit breaker, always turn the starting switch OFF first. No. Fuse Capacity Circuit Name 1 40A Fuse 1 to 15 2 20A Work equipment headlamp, right side headlamp 3 20A Power supply grease pump 4 20A Pump controller 5 20A Cab upper headlamp 6 20A Starting switch, Pump controller 7 30A Engine controller 8 20A Monitor,buzzer 9 20A Fuse 16 to 20 3 - 74 If the starting switc h does not work, even when the starting , open the circuit breaker box inside the ocated at the front right of machine, and t is generated, the circuit breaker cuts off starting switch is turned on grease pump box l perform inspection.
side the If an excess curren electrical current to from damage. To re after it has been cut If the electric circu remains in. If the re it is pushed in, it is n protect electrical components a nd wiring turn the circuit electrical current t off, push in the reset button. it is working normally, the rese o normal t button set button pops out again immedia tely after ecessary to check the electric circ uit. REMARK The circuit breaker is a circuit protection device installed to circuits where larg components and w current in the same restoring the locati replace the breaker e current flows. It protects the iring from damage caused by an a electrical bnormal way as a normal fuse.
After repa iring and on of the abnormality, there is no need to . It can be used again. or does not work even when the starting If the starting mot switch is turned to t off the circuit, so ch he ON position, breaker (6) has pro bably cut eck and restore circuit breaker (6) . If the electrical equi pment does not work even when th e fuse is replaced, breaker ( check and restore c 1) or (9) has probably cut off the circuit, so ircuit breaker (1) or (9).