. OPERATION DETAILED CONTROLS AND GAUGES Precautions when Using and the nozzle at the tip of the Supplying Grease 1. Remove 3 wing bolts (2) from grease can (1), then remove cover (3) from the pump. 2. Remove follow plate (4) inside the grease can. short time and then stop, but the first grease includes air inside the pump, so it is 3 - 77 NOTICE When not using the grease pump, al ways turn power switch (1) OFF so that there is no internal pressure on gr ease gun (2), and release the pressure inside the hose.
grease gun are perpendicula When removing the nozzle at tip of the grease gun from the le the tip of nozzle slightly and mount of grease left in the grease grease fitting, carefully ang remove it. When there is only a small a can, the pump will not pump out grease, so move grease to the center or fill the can with new grease. 3. Fill grease can (1) with fresh grease, set follow plate (4) on top of the grease so that it is ho until grease comes out from plate (4). When setting the follow inside of the raised part i grease.
This will make th rizontal, then push down by hand the packing in the center of follow plate on top of the grease, fill the n the center of the follow plate with e operation go more smoothly. 4. Insert the pump into the pac king at the center of follow plate (4), set cover (3) on grease ca uniformly to hold in position n (1), then tighten 3 wing bolts (2) . The pump will operate for a cloudy white and not suitable