. OPERATION MACHINE OPERATIONS AND CONTROLS Check Oil Level in Hydraulic Tank, Add Oil WARNING pressure. 3 - 86 If the oil filler cap is removed without releasing the in ternal pressu re, oil will spurt out, so turn t he oil filler cap s lowly to release the i nternal pressure , then remove it 1. If the machine is not in the co ndition shown in the diagr am on the right, start the engine, run the engine at low speed, retract the arm and b ucket cylinder ro ds fully, lower the boom, put the bucket teeth in contact with th e ground, the n stop the e ngine. 2.
Within 15 sec onds after sto pping the en gine, turn s tarting switch to the O N position, and operate the c ontrol levers (work nternal 3. Open cover (1 ) on the left side of the machin e and chec k sight gauge (G). Th e oil level shoul d be between t he H and L marks. NOTICE Do n ot add oil if the l evel is above the H line. This will d amage the hy draulic equipment and caus e the oil to spurt