Komatsu — STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS Ambient temperature Lighting time - 5 ° C (23 ° F) 20 seconds - 20 ° C (- 4 ° F) 40 seconds - 10 ° C (14 ° F) 25 seconds 4. If the preheating monitor does not light up, or it lights up and then goes out to inform that the engine preheating has been completed, turn the key in starting switch (3) to the START position (C) and start the engine. REMARK If the ambient temperature is low, the engine may not start even when the key in the starting switch (3) is kept at the START position for 20 seconds. If this happens, wait for at least 2 minutes, then start again from the beginning. 5.

After the engine starts, release the key in starting switch (3). The key will automatically return to the ON position (B). 6. Even after the engine is started, do not touch the work equipment control levers and the travel pedals, while the engine hydraulic pressure monitor lamp is still lighted. NOTICE If the engine oil pressure monitor does not go out even after 4 to 5 seconds have passed, stop the engine immediately. Check the oil level, check for leakage of oil, and take the necessary action. 3 - 99 3. Turn the key i n starting s witch (3) to O N position ( B). If the ambient temperature is lo w, the p reheating m onitor lights up and automatic preheating is c arrie d out .

Kee p the key in starting switch (3) at the ON position (B) until the preheating until monitor goes out. The time tha t the preheating monitor stays lighted up depends on the ambient temperature as show n in the t able on the right.