Komatsu — AFTER STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS on the internal structure of the engine at idling for more than 20 minutes, apply a load from time to time or run at a mid-range speed. temperature monitor (1) displays procedure in Step 3 to carry out until the monitor displays run the engine at a mid-range load until engine water temperature 3 - 102 Engine Warm Up NOTICE Do not accelerate the engine sudde been completed. Do not run the engine at low idling o than 20 minutes. This will have an and will also have an adverse effe engine. If it is necessary to run th minutes, apply a load from time to t After the engine starts, do not start operating the machine immediately.

First, carry out the fo llowing operations and checks. 1. This machine is equipped wit below 30 °C after the engine i automatic warm-up operation s speed. If the engine water temperatur 10 minutes, the automatic war speed. h an automatic engine warm-up system, so if the engine water temperature is 1. 1. below 30 °C after the engine i s started, the engine warm-up operation starts automatic ally. When the engine automatic warm-up operation s tarts, the engine speed is maintained at a speed higher th an the normal low idling speed.

If the engine water temperatur e goes above 30 °C or if the warm-up operation has been c ontinued for more than 10 minutes, the automatic war m-up operation is cancelled and the engine speed drops to the normal low idling speed. 2. Check that engine water tem green. If it displays white, use the pr additional warm up of the en green. 3. Turn fuel control dial (2) to a p (MIN) and full speed (MAX), speed, and run under no load monitor (1) displays green. If the engine water temperature m onitor displays green, the engine warm-up operation is c ompleted. After checking that the engine wate r temperature monitor displays green , carry out the warmi ng-up operation for the hydraulic equipment.