Komatsu — WORK EQUIPMENT CONTROLS AND OPERATIONS

. OPERATION MACHINE OPERATIONS AND CONTROLS WORK EQUIPMENT CONTROLS AND OPERATIONS WARNING held in that engine speed to a engine stopped, it is 3 - 118 If t he lever is op erated when the engi ne speed ha s been lowered by the auto-deceleration function, the eng rise, so operate the levers carefully. Use the contr ol levers to operat e the work Note that whe position. If the work e quipment control levers are r eturned to th e neutral position when the machine i fuel control dial is set to FULL, the auto-deceleration mechanism will act to reduce th peed.

to-decelerati mid-range s REMARK With this mach ine, an accumula tor is install ed in the ope rating circuit, if less than 15 seconds engine was st opped, when the starting sw itch is turne d to t he possible to op erate the levers to lower wor k equipment to the In addition, thi s operation can al so be used to release t he remaining pressure in the hydrauli lower the boo m after the machi ne has bee n loaded ont o a trailer Arm control Move the le ft work equipment control lev er to the fron t or rear t operate the Swing contr ol Move the le ft work equipmen t control lev er to the left or right t swing the u pper structure.

Boom contr ol Move the ri ght work equipme nt control l ever to the fr ont or rea to operate t he boom.