Komatsu — MACHINE INSPECTION AFTER DAILY WORK

. OPERATION MACHINE OPERATIONS AND CONTROLS OPERATION MACHINE OPERATIONS AND CONTROLS 3. Lower the bucket horizontally until the bottom touches the ground. MACHINE INSPECTION AFTER DAILY WORK 3 - 135 4. Set lock lev er (3) in the LOCK positio 5. Use the machine monitor to ch eck the engine temperatur If the coo to cool u the engin see "TRO If the eng immediat see "TRO temperatur e, engine oil pressure, an If the coo lant temperature gauge is in the red range , allow it ntil the indicator enters th e black range, th en stop e. For details of the insp UBLES AND ACTIONS ection and action (PAGE 3-153)". to take, ine oil pressure monitor l ely.

For details of the insp ights up, stop the ection and action engine to take, UBLES AND ACTIONS (PAGE 3-153)". 6. Stop the en gine. For details on the p rocedure for stopping the engine, see "STOPPING THE ENGI NE (PAGE 3-110)". 1. Walk aroun d the machine and check the work equipment, machine exterior, and under carriage, also check for any leakag e of oil or coolant. If any p roblems are found, repair 2. Fill the fuel 3. Check the e ngine compartment for p aper and debris. Clean ou t any paper and debris 4. Remove an y mud affixed to the unde