. OPERATION TROUBLES AND ACTIONS Starting Engine with Booster Cables When starting the engine with a booster cable, do as follows. Connecting and Disconnecting Booster Cables WARNING of battery (C) on the problem machine. 2. Connect the clip at the other end of booster cable (A) to the positive (+) terminal of battery (D) on the normal machine. of battery (D) on the normal machine. 4. Connect the other clip of booster cable (B) to the revolving frame (E) of the problem machine. 3 - 158 When connecting the cables, nev er contact the positive (+) and negative (-) terminals. When starting the engine with glasses.
a booster cable, always wear safety Be careful not to let the normal m achine and problem machine contact each other. This prevents sparks f rom generating near the battery which could ignite the hydrogen gas giv en off by the battery. If hydrogen gas explodes, it could cause serious injury. Be careful not to make a mistake when connecting a booster cable. In the last connection (to the upp caused, connect the cable to a er structure frame), a spark will be spot as far away from the battery as possible.
(Avoid the work equipm ent, however, because it is not a good conductor) When removing the booster ca ble, exercise good care so that the tact each other, or they contact the booster cable clips may not con chassis. NOTICE The starting system on this mach ine is 24 V. Always use a 24 V machine for the normal machine Always use a booster cable or cli p of a thickness that is suitable for the size of the battery. For the battery on the normal ma chine, use a battery with the same capacity as the problem mach Check that the cable and clips ar e not damaged or corroded. machines are at the LOCK position. utral position. Connect the clips securely.
Check that the lock levers of both machines are at the LOCK position. Check that all levers are at the ne Booster Cable Connection Keep the starting switch of the n ormal machine and problem machine in t he OFF position Connect the booster cable as fo llows, in the order of the numbers marked in the diagram. 1. Connect the clip of booster c able (A) to the positive (+) terminal 3. Connect the clip of booster c able (B) to the negative (-) terminal