Komatsu — TIGHTENING TORQUE LIST

. MAINTENANCE TIGHTENING TORQUE SPECIFICATIONS TIGHTENING TORQUE SPECIFICATIONS TIGHTENING TORQUE LIST CAUTION Apply the following table for Hydraulic Hose. Permissible range 35 - 54 (3.5 - 5.5) 54 - 93 (5.5 - 9.5) 84 - 132 (8.5 - 13.5) 128 - 186 (13.0 - 19.0) 177 - 245 (18.0 - 25.0) 176 - 234 (18 - 24) 4 - 12 If nuts, bolts, or othe r parts ar e not tightened to the specified torque, i t wil l cause looseness or dam age to the tightened parts , and this wil l cause failur e of the m achine or problems with operation. Always pay careful a ttention when tightening parts Unless otherwise specifie d, tighten the metric nuts and bolts to t he torque shown in the table below.

If it is n ecessary to replace any nut or bolt, always use a Komatsu genuine part of the sa me size as the part that was replaced.

Thread diameter of bolt (a)(mm) Width across flats (b)(mm) Tightninig torque [Nm (kgm)] Target value Permissible range Permissible range 6 8 10 12 14 10 13 17 19 22 13.2 (1.35) 31 (3.2) 66 (6.7) 113 (11.5) 177 (18.0) 11.8 - 14.7 (1.2 - 1.5) 27 - 34 (2.8 - 3.5) 59 - 74 (6.0 - 7.5) 98 - 123 (10.0 - 12.5) 157 - 196 (16.0 - 20.0) 16 18 20 22 24 24 27 30 32 36 279 (28.5) 382 (39.0) 549 (56.0) 745 (76.0) 927 (94.5) 245 - 309 (25.0 - 31.5) 343 - 425 (35.0 - 43.5) 490 - 608 (50.0 - 62.0) 662 - 829 (67.5 - 84.5) 824 - 1030 (84.0 - 105.0) 27 30 33 36 39 41 46 50 55 60 1320 (135.0) 1720 (175.0) 2210 (225.0) 2750 (280.0) 3280 (335.0) 1180 - 1470 (120.0 - 150.0) 1520 - 1910 (155.0 - 195.0) 1960 - 2450 (200.0 - 250.0) 2450 - 3040 (250.0 - 310.0) 2890 - 3630 (295.0 - 370.0) 42 65 3830 (390.0) 3430 - 4220 (350.0 - 430.0) Nominal No.

of hose Width across flat b(mm) Target value 02 19 44 (4.5) 03 22 74 (7.5) 04 27 103 (10.5) 05 32 157 (16.0) 06 36 216 (22.0) 10 41 215 (22)