Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE (2), then remove cover (3). at an it in 4 - 22 Install Air Clean 1. Open the cov er at the left sid e of the mac hine, remove 6 2. Hold the out er element (5), rock it lightly up and down a the left and ri ght, and rotate the element t o the left and ri pull it out. Do not remo ve inner elemen t (6) when d 3. When the ou ter element (5) has been rem oved, check th inner elemen out of posi tion and is not angle. If is i straight. 4. Wipe off or br ush off the dirt s tuck to cove r (3) and the ins the air clean 5. Remove any dirt or dust that i s accumulat ed to evacuator (4) installed t NOTICE The inner eleme nt must not be cl eaned and us ed again.

When r eplacing the outer element, repl ace the inner elemen t at the same time. If the inner elem ent is not installed properly and the outer element and cov er are installed, there is d anger that the outer e lement will be damaged . The seal portion on imitation part s lacks precisi on, and allows th e entry of dust, which leads to d amage of the engine. Do not use such imitati on parts. 6. Remove inne r element (6), t hen quickly i nstall the new i Insert the inn er element securely so that it does not mov 7.

Push the ne w outer element (5) in straig ht with your han d when installing it to the air If the elemen t is held and rocked lightly up and down and to the l eft and right while pus hing it in, the eleme nt can be inserted e