. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 45 (10) Link c oupling p in (2 place (11) Buck et cylinde r rod pin (1 place) (12) Bucket-Link co upling pin ( 1 place) EVERY 100 HOURS MAINTENANCE Maintenance for ev ery 10 hour s service should be carried out at the LUBRICATING SWING CIRCLE (3 places) 1. Lower the work equipment to the ground. 2. Using a greas e pump, pu n grease fittings shown b y arrows. 3. After g reasing, wipe off an y old grease that was pushed out. the grease