Komatsu — EVERY 1000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 2. Set the container to catch the fuel under the filter cartridge. 3. Using a filter wrench, turn filter cartridge (2) counterclockwise to remove it. 4. Clean the filter holder, coat the packing surface of the new filter cartridge thinly with oil, then install the filter cartridge to the filter holder. 4 - 63 NOTICE Do not fill the f uel filter cartridge wit Remove cap (B ) and install the fuel f 5. When install ing, tighten until th e packing surface contacts the seal surface of the filter h older, then tighten it 3/4 of a turn.

If the filter c artridge is tightene d too far, the pac king will b e damaged and this will lead t o leakage of fuel. If the filter cartridg e is too loose, fuel will also leak fro m the packing , so always tighten the co rrect amount. filter. When tigh tening with a filter wrench, be extre mely careful n ot t o dent or damage the 6. After comple ting the replacem ent of fue l main fi lter cartridge ( 2), b leed the air. Bleed the air as 7. Loosen plug (A) at the top of fu el main f ilter cart NOTICE Do not loosen the plug of the fuel pre-fil ter head. T his is at the suction end, so if it is loosened , it will be impossible to bleed the air.