. ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE instead of at the full stroke to control the remover link rising speed. 6 - 12 Operate counterweight remov slowly to the RAISE (f) posit cylinder (9) to the stroke end ( max.). Then B remover link (10) begins to rise as it is stretched . In this process, raise B remover link (10) slowly by keeping B control lever (8) at its half stroke 6. Operate counterweight remo val / installation A control lever (11) slowly to the LOWER (f) position, allowing A remover link (12) to be stretched.
In this pr ocess, lower A remover link (12) slowly by keeping A control le ver (11) at its half stroke instead of at the full stroke to control t he remover link lowering speed. 7. Position the machine and the counterweight to face each other squarely, and then stretch A r emover link (12) until the pin hole of B remover link (10) and the pin hole of the counterweight are on the same level. Operate the machine back a remover link (10) and the pi nd forth until the pin hole of B 8. n hole of the counterweight are aligned. This can be done thr ough a fine control of B remover link (10). After both pins are aligned, in stopper bolts (13).
Operate counterweight remo sert 2 pins (14) and install 2 pin val / installation A control lever 9. 10. (11) slowly to the RAIS E (e) position, allowing the counterweightto rise. At that ti me, keep B remover link cylinder (9) at the full stroke (max.), a nd raise the counterweight until k (12) is upright. the backside of A remover lin 11. Operate counterweight remov al / installation B control lever (8) slowly to the LOWER (e) pos ition, allowing the counterweight to settle in the seat.
In this p rocess, lower the counterweight slowly by keeping B control le ver (8) at its half stroke instead of at the full stroke to control the lowering speed and make sure that the counterweight settles in the seat safely and neatly. REMARK In case the mounting holes of the counterweight and revolving frame a re misaligned, try to align them properl y by operating A remover link cylinder (15) and B remover link cylinder (9) . When both holes are aligned, release the remaining pressure inside the cyli nders and mount the counterweight neatly on the seat of the revolving fram e.