Operation Section 1 ± 33 DTC Code Detection Item DTC Description Remarks P0336 Crankshaft Position Sensor Pulse Number Abnormality Possible causes include the use of an incorrect pulsar, and/or an abnormality in the wiring harness (intermittent open circuits, etc.) P0340 Camshaft Position Sensor Malfunction Issued when the pulse from the engine speed sensor cannot be detected. Possible causes include sensor and/or harness malfunctions.
P0341 Camshaft Position Sensor Pulse Number Abnormality Possible causes include the use of an incorrect pulsar, and/or an abnormality in the wiring harness (open circuit, modifications, etc.) P0400 Excessive Exhaust Gas Recirculation (EGR) Rate Issued when the EGR rate is excessive in relation to the intake quantity. Possible causes include a malfunction in the MAF meter, EGR valve, EGR actuation ECU, and/or an open or short circuit in the wiring harness. P0400 Insufficient EGR Rate Issued when the EGR rate is insufficient in relation to the intake quantity.
Possible causes include a malfunction in the MAF meter, EGR valve, EGR actuation ECU, and/or an open or short circuit in the wiring harness. P0500 Vehicle Speed Sensor Malfunction (Lo) Issued when the pulse from the vehicle speed sensor cannot be detected. Possible causes include sensor and/or harness malfunctions. P0501 Vehicle Speed Sensor Malfunction (Hi) Issued when the pulse from the vehicle speed sensor cannot be detected. Possible causes include sensor and/or harness malfunctions. P0504 Brake Switch Malfunction Issued when the brake switch cannot be correctly detected. Monitor brake switch status, and verify ON/OFF judgments.
P0510 Idle Switch (Stuck ON) Issued when the idle switch is malfunctioning. Monitor switch status and check the ON/OFF judgment. P0524 Engine Oil Pressure Abnormality Issued when engine oil pressure is too low. P0540 Preheat Device Malfunction (Ground Short, +B Short, Open) Issued when the intake heater relay is malfunctioning. Possible causes include relay and/ or wiring harness malfunctions. P0545 Exhaust Gas Temperature Sensor 1 Malfunction (Lo) Issued when temperature cannot be correctly detected. Possible causes include a sensor malfunction and/or a short circuit to ground in the wiring harness. Vehicles with DPF Installed