MAN Nutzfahrzeuge — EGR actuator (permanent deviation)

Testing EGR actuator (permanent deviation) Flash code: 3x long, 11x short Fault indication: Fault is not indicated by the EDC indicator lamp Fault path: EGR actuator Effect of fault: EGR function not available Possible cause: Cable interrupted, short–circuit, check–back switch defective, mechanical de- fect on actuator Test precondition: Socket box connected Note: In diagnosis mode the EGR actuator test can be activated via MAN-Cats. If the fault memory is read out after the actuator test it always contains the fault 3B Hex. ”EGR actuator, permanent deviation” (3x long, 11x short), even if the fault was deleted before the actuator test.

Although it is unsatisfactory for service, this behaviour is unfortunately unavoi- dable and is correct for the coded software. The fault memory must therefore be deleted without fail after the EGR actua- tor test. Note vehicle–specific circuit diagrams 60 Test Measurement Corrective measures Check-back switch (reed contact) Measure resistance at the socket box across pin 15 and pin 24 Set-point value: >1 Ω – Check lines – Check plug connections – If no fault found, replace control unit Solenoid valve triggering Measure resistance at the socket box across pin 39 and pin 18 Set-point value: 39–47 Ω – Check lines – Check plug connections – If no fault found, replace control unit