Komatsu — TROUBLESHOOTING OF HYDRAULIC AND MECHANICAL SYSTEM (H- MODE)

TROUBLESHOOTING H-MODE TROUBLESHOOTING OF HYDRAULIC AND MECHANICAL SYSTEM (H-MODE) TABLE OF FAILURE MODES AND CAUSES FOR HYDRAULIC AND MECHANICAL SYSTEM In the failure modes, modes for compound operations are used when independent operations are normal When there is an abnoramlity for both front and rear 20-206 Parts cusing failure Failure mode Piston pump Self pressure reducing valve Strainer Damper F R TVC valve LS valve Servo piston Pump prooper PC valve LS valve Servo piston Pump proper All work equipment, travel, swing Speeds of all work equipment, swing, travel are slow or lack power          There is excessive drop in engine speed, or engine stalls       No work equipment, travel, swing move     Abnormal noise generated (around pump)    Auto-deceleration does not work Fine control ability is poor or response is poor     Compound Work equipment operations Boom is slow or lacks power Arm is slow or lacks power Bucket is slow or lacks power Boom does not move Arm does not move Bucket does not move Excessive hydraulic drift Escessive time lag (engine at low idling) Other equipment moves when single circuit is relieved Lack of power when pressure rises In L/O, F/O modes, work equipment speed is faster than specified speed   In compound operations, work equipment with larger load is slow In swing + boom (RAISE), boom is slow In swing + arm, arm is slow In swing + travel, travel speed drops excessively Travel system Travel deviation Deviation is excessive    Deviation is excessive when starting Travel speed is slow Steering does not turn or lacks power Travel speed does not switch or is faster than specified speed Does not move ( one side only)   Swing system Does not swing Both left and right One direction only Swing acceleration is poor or swing speed is slow Both left and right One direction only Excessive overrun when stopping swing Both left and right One direction only Excessive shock when stopping swing (one direction only) Excessive abnormal noise when stopping swing Exessive hydraulic drift of swing When brake ON When brake OFF Swing speed is faster than specified swing speed