TROUBLESHOOTING M-CODE M-2 [E103] Short circuit in buzzer output or contact of 24V wiring harness with buzzer drive harness is displayed # If the starting switch is turned OFF after an abnormality occurs, turn the starting switch ON and check if an E service code is displayed. (If it is not displayed, the system has been reset.) # Before carrying out troubleshooting, check that all the related connectors are properly inserted. # Always connect any disconnected connectors before going on the next step. Table M-2 Related electric circuit diagram 20-246 2 YES Is voltage between YES P04 (2) and chassis 1 normal?
Is resistance be- tween P04 (male) (1) • Turn starting switch NO - (2), (2) - chassis as ON. shown in the table? • Buzzer ON: Max. 1V • Buzzer OFF: 20 - 30V • Turn starting switch OFF. NO • Disconnect P04. Cause Remedy Defective monitor panel Short circuit with power source in wiring harness between P01 (female) (7) and P04 (female) (2) or short circuit in wiring harness between P04 (1) and (2) Defective buzzer Replace Repair or replace Replace P04(male) Resistancevalue Between(1)and(2) 200-300 Between(2)andchassis Min.1M