DISASSEMBLY AND ASSEMBLY CENTER SWIVEL JOINT Disassembly 1. Remove cover mounting bolts (1) (4 places), cover (2) and O-ring (3). 2. Remove thrust plate mounting bolts (4) (4 places), thrust plate (5) and O-rings (6) (4 places). 3. Remove shaft (7) from housing (8). 4. Remove seals (9) and (10) from housing (8). # Check all seals and O-rings for damage or wear and replace if necessary. Assembly 1. Assemble seals (9) and (1) to housing (8). 2. Set shaft (7) on a block, then using push tool, tap housing (8) with a plastic hammer to install. Contact surface of housing, shaft: Grease (GS- LI) # When installing the shaft, be extremely careful not to damage the seals or O-rings. 3.
Install O-rings (6) and thrust plate (5). 4. Fit O-ring (3) and install cover (2). Mounting bolt: 31.36 ± 2.94 Nm (3.2 ± 0.3 kgm) 30-44