DISASSEMBLY AND ASSEMBLY SWING MACHINERY 4. Using tool F , press fit bearing (36). # Press the bearing inner race and outer race at the same time when press fitting. Do not press only the inner race when press fitting. # After press fitting the bearing, check that the case ro- tates smoothly. 5. No. 2 carrier assembly a. Assemble No. 2 carrier assembly as follows. # There are the remains of the caulking when the pin is inserted at the end face of hole h at the side of the carrier, so remove the caulked metal from the inside diameter of the hole before starting to assemble. i. Assemble plate (27) to carrier (22). ii.
Assemble bearing (25) to gear (24), fit top and bottom thrust washers (23) and (26) and set gear assembly to carrier (22). iii. Align position of pin holes of shaft and car- rier, then tap with a plastic hammer to install shaft (21). # When installing the shaft, rotate the planetary gear. Be careful not to damage the thrust washer. iv. Insert pin (20). # After inserting the pin, caulk the pin portion of the car- rier. b. Install No. 2 carrier assembly (19). 6. Tighten bolt (18). Thread of mounting bolt: Thread tightener (LT-2) Mounting bolt: 176.4 ± 19.6 Nm (18 ± 2.0 kgm) 30-61