DISASSEMBLY AND ASSEMBLY RECOIL SPRING ASSEMBLY OF RECOIL SPRING ASSEMBLY 1. Assembly of piston assembly 1) Assemble ring (14) and U-packing (13) to piston (9), and secure with snap ring (12). 2) Tighten valve (11) temporarily, and secure with lock plate (10). 2. Assembly of recoil spring assembly 1) Using tool H 2 , install dust seal (8) to cylinder (7). 2) Assemble cylinder (7) and yoke (6) to spring (5), and set in tool H 1 . Sliding portion of cylinder: Grease (G2-LI) 3) Apply hydraulic pressure slowly to compress spring, and tighten nut (4) so that installed length of spring is dimension “ a ”, then secure with lock plate (3)? # Installed length “ a ” of spring: 466 mm.
4) Remove recoil spring assembly (1) from tool H 1 . 3. Assemble piston assembly (2) to recoil spring assem- bly (1). Sliding portion of piston, wear ring: Grease (G2-LI) # Assemble the cylinder assembly so that the mounting position of the valve is 90° to the side. # Fill the inside of the cylinder with 300 cc of grease (G2-LI), then bleed the air and check that grease comes out of the grease hole. 30-70