Hydraulic Brake System, Bosch 42.15 Pressure Testing Brake System Pressure Tests If the residual pressure on one or both gauges is more than 2 psi (14 kPa), check the linkage be- tween the brake pedal and the booster. Repair the linkage if needed. Repeat steps 3 and 4. If the problem is solved, go to "System Pressure Test" below. If the problem is not solved, con- tinue these steps. NOTE: On most vehicles in the field, the pri- mary master cylinder piston controls the rear brakes, the secondary piston, the front brakes. But on some vehicles the primary master cylin- der piston controls the front brakes, the second- ary master cylinder piston controls the rear brakes.
Either configuration is considered nor- mal and they are functionally identical. Techni- cians should check vehicle configuration for ap- propriate diagnosis and repair. 6. Check the hydraulic lines for internal blockage or kinking and replace them as needed. Repeat steps 3 and 4. If the problem is solved, go to "System Pressure Test" below. If the problem is not solved, continue with these steps. 7. Check for residual pressure at the master cylin- der. Replace as needed. Go to "System Pressure Test" below. System Pressure Test 1. Install two low-pressure gauges with a range of 0 to 50 psi (345 kPa) one at the rear wheels, and one at the front wheels. See Fig. 1 . 4 5 1.
Install two pressure gauges with a range of 0 to 2500 psi (17,250 kPa) one at the rear wheels, and one at the front wheels. See Fig. 1 . 1 2 3 2. Bleed the brakes following the procedure under Subject 110 . 6 7 3. Make a copy of Table 1 . Use this copy to record the results from the next step. A B Test Results 04/16/2003 f430339 Pressure Test Gauge 1 (installed at rear wheel) Gauge 2 (installed at front wheel) A. Install gauge #2 here. B. Install gauge #1 here. 1. Front Brake 2. Front Brake Lines 3. Master Cylinder 4. Reservoir 5. Power Brake Booster 6. Rear Brake Lines 7. Rear Brake Rapid Pressure Rise Yes No Yes No Highest Reading (psi) psi psi Slow Pressure Rise Yes No Yes No Fig.
1, Gauge Installation Pressure Constant Yes No Yes No 2. Bleed the brakes following the procedure in Sub- ject 110 . Table 1, Test Results 4. Start the engine. Quickly apply the brakes using full pedal force. Hold the pedal down for 15 to 20 seconds. Record the speed of the pressure rise, the highest pressure registered on each gauge and whether the pressure stayed constant while the pedal was held down. Use a copy of Table 1 to record your observations. 3. With the ignition off, lightly apply the brakes sev- eral times. Do not push hard on the brake pedal or you may damage the low-pressure gauges. 4. Release the brakes. Read the residual pressure on both gauges. Record the information. 5.
If the residual pressure on either gauge is less than 2 psi (14 kPa), go to "System Pressure Test" below. 5. If the pressure reading on both gauges is not within 10 percent, the ABS may be affecting readings ( Section 42.26 ). Replace the master cylinder if needed. Remove the pressure gauges. Business Class M2 Workshop Manual, Supplement 8, September 2005 310/1