Freightliner — Freightliner Business Class M2 Workshop Manual

Tandem Brake Chambers, MGM 42.24 Power Spring Manual Compression and Reset the bolt until it bottoms out into the hole in the piston inside the chamber. 3.5 Holding the bolt locked into the piston, install the flatwasher and release nut on the end of the release bolt, and turn down the nut against the flatwasher until it is finger-tight. See Fig. 5 . f421353 05/24/95 Fig. 3, Remove the Release Bolt f421354 05/12/93 Fig. 5, Flatwasher and Release Nut Installed CAUTION Do not exceed 50 lbf·ft (68 N·m) torque on the release nut; and do not use an impact wrench on this nut. Too much torque could distort the head of the chamber and prevent manual release of the parking brake.

3.6 Using a hand wrench ( do not use an im- pact wrench), turn the release nut clock- wise until the bolt extends 3 inches (76 mm) above the nut. See Fig. 6 . f420422a 05/21/93 Fig. 4, Insert the Release Bolt IMPORTANT: Do not exceed the 3-inch (76- mm) length. IMPORTANT: If you are not absolutely sure that the formed end of the bolt has engaged the piston correctly, repeat this step. Repeat it until you are absolutely sure. 4. Once the power spring has been caged, exhaust the compressed air from the parking brake. 3.4 Turn the release bolt one-quarter turn clockwise, and pull the bolt out to lock its formed end into the piston. Manual Reset (Parking Brake Reset) IMPORTANT:

If the bolt does not lock into the piston in less than a 1/2 inch (13 mm) outward movement, repeat these steps until you are sure it does lock. 1. Uncage the power spring. 1.1 Apply at least 90 psi (620 kPa) air pres- sure to the parking brake inlet port (set parking brake in the "release" position). Business Class M2 Workshop Manual, Supplement 3, November 2002 100/2