Freightliner — Freightliner Business Class M2 Workshop Manual

Tractor Protection Valve, Bendix TP–3DC 42.25 Disassembly, Cleaning and Inspection, and Assembly 3. Remove the two 1/4-inch screws which secure the valve cover to the valve body and allow the valve spring to expand until the valve cover can be removed. Assembly IMPORTANT: Before working on or around air brake systems and components, review Safety Precautions, 100 . 4. Remove the cover O-ring and discard it. 5. Remove the diaphragm from the valve body and discard it. 1. Lubricate the O-rings, O-ring grooves, body bores, and all sliding parts with the lubricant pro- vided in the overhaul kit (Bendix silicone lubri- cant #291126 or equivalent). 6. Remove the guide from the valve body. 7.

Remove the O-rings from the guide and discard them. 2. Install the O-rings on the plunger. 8. Remove the valve spring from the plunger, then the plunger from the valve body. 3. Install the O-ring on the plunger and then the collar over the O-ring. Make sure that the collar is fully seated and firmly in place over the O-ring. 9. Remove the O-rings from the plunger and dis- card them. 4. Install the plunger into the valve body and the spring into the plunger. 10. Remove the collar and the O-ring from the plunger. Discard the O-ring, but keep the collar. 5. Install the O-rings in their grooves on the guide. Cleaning and Inspection 6.

Align the indexing tab on the guide with the notch in the valve body and install the guide in the valve body. IMPORTANT: Before working on or around air brake systems and components, review Safety Precautions, 100 . 7. Place the diaphragm in its recess on the guide. 8. Place the O-ring on the cover. 9. Place the cover on the guide and press them down, against spring pressure, until the cover is seated against the valve body. WARNING Wear goggles when using compressed air to clean or dry parts, as permanent harm to eyes could result from flying debris. 10. Install the two 1/4-inch screws and tighten them 30 to 60 lbf·in (340 to 675 N·cm). 1.

Wash all metal parts of the TP–3DC valve in cleaning solvent, then dry them using com- pressed air. 11. Install the TP–3DC valve on the vehicle following the instructions in Subject 120 . 2. Examine the cover, body, guide, and plunger for corrosion, excessive wear, cracks, or other dam- age. If any of these conditions are found on a part, replace the part with a new one. 3. Check the spring for distortion and corrosion. If the spring is distorted or corroded, replace it. 4. Check the valve body bores for deep scratches or gouging. Business Class M2 Workshop Manual, Supplement 0, January 2002 130/2