Freightliner — Freightliner Business Class M2 Workshop Manual

Fuel Tanks and Fuel Lines 47.00 Fuel Shutoff Valve Replacement, EPA10 Engines Replacement bracket. Remove the tee fittings and valves as an assembly. NOTE: Fuel shutoff valves are only installed on vehicles with dual tanks. 11. Remove the shutoff valves from the tee fittings, then install new shutoff valves. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Put the transmission into high gear, chock the tires and open the hood. 12. Using two jam nuts, install the tee fitting and shutoff valve assembly on the EquiFlo bracket. 13. Install the fuel lines on the tee fittings and tighten the fittings. 2.

Disconnect the fuel control rod(s) from the fuel shutoff valve lever(s). Swing the control rod(s) out of the way without removing them from the control rod mounting bracket. See Fig. 1 . 14. If any ATD wiring harness standoff brackets were previously removed, install them on the EquiFlo bracket, then connect the wiring harnesses. 15. If any DEF line standoff brackets were previously removed, install them on the EquiFlo bracket. WARNING Aftertreatment device (ATD) internal temperatures can remain hot enough to cause personal injury or ignite combustible materials for hours after the engine is shut down, causing potentially seri- ous burns or material damage.

Wear appropriate protective gear when working around the ATD. Do not to let diesel from the fuel lines come into contact with the ATD. 16. Connect the DEF coolant lines. 17. Connect the ATD wiring harnesses. 18. Install any remaining cables and brackets that were previously removed. 19. Connect the driveline to the transmission output yoke. For instructions, see Section 41.00, Sub- ject 100 for coupling to a half-round end-yoke, or Section 41.00, Subject 110 for coupling to a full-round end-yoke. 3. Disconnect the driveline from the transmission output yoke.

For instructions, see Sec- tion 41.00, Subject 100 for uncoupling from a half-round end-yoke, or Section 41.00, Sub- ject 110 for uncoupling from a full-round end- yoke. 20. Connect the midship bearing to the midship bearing bracket. 21. Connect the control rod(s) to the fuel shutoff valve lever(s). Tighten the nuts 16 lbf·ft (22 N.m). 4. Disconnect the driveline midship bearing from the midship bearing bracket, and set the driveline out of the way. 22. Start the engine and check for leaks. 5. Disconnect the aftertreatment device (ATD) wir- ing harnesses located on the EquiFlo bracket. 6. Disconnect the diesel exhaust fluid (DEF) coolant lines located on the EquiFlo bracket. 7.

Disconnect the fuel lines from the tee fittings, then cap the lines. 8. In order to gain access to the fuel shutoff valves, it may be necessary to remove the standoff brackets that secure the DEF lines to the EquiFlo bracket, then move the lines aside. See Fig. 1 . 9. Remove any remaining cables and brackets as needed to access the fuel shutoff valves. 10. Loosen the two jam nuts that secure the fuel shutoff valves and tee fittings to the EquiFlo Business Class M2 Workshop Manual, Supplement 20, September 2011 160/1