Batteries 54.03 Battery Box Removal and Installation 3. Pull on the end of the holddown latch until the end clears the cover-mounted catch. Pivot the latch out of the way, then lift off the battery box cover. See Fig. 2 . 4. Install the battery holddowns. Tighten each nut to 10 lbf·ft (14 N·m). CAUTION Do not overtighten the battery holddowns. Over- tightening could damage the batteries. 5. Place the battery box cover over the battery box and fasten the latch. 5 4 3 2 1 2 06/05/2003 f544323 1. Battery Box 2. Bracket, Battery Box 3. Holddown Bolt 4. Holddown 5. Battery Box Cover Fig. 2, Steel Battery Box (typical) 4. Remove the fasteners that hold the battery box to the brackets. 5.
Remove the battery box. Installation 1. Line up the holes in the battery box with the holes in each mounting bracket. 2. Install the fasteners that attach the battery box to the mounting brackets. Tighten the fasteners to 18 lbf·ft (24 N·m). 3. Place the batteries in the battery box with the terminals in the proper position. Make sure the batteries rest level in the box. See Subject 160 for procedures to correctly install the batteries. Business Class M2 Workshop Manual, Supplement 10, September 2006 170/2