Datalinks 54.10 Troubleshooting the J1939 Datalink Use the following test procedures in the order given to successfully locate J1939 datalink problems. Do not skip test procedures or steps unless directed to do so. nostic connector through the backbone loop. It does not ensure that branch circuits to each ECU are okay. Test 1: J1939 Resistance Test IMPORTANT: The batteries must be discon- nected prior to any J1939 resistance tests being performed. Failure to do so may result in incon- clusive resistance measurements. Test 2: ECU Communication Test Using Datalink Monitor Template Test 3: Testing J1939 for Circuit Faults (shorts to power and ground) 1. Turn the ignition off. 2.
Disconnect the negative leads from the batteries. Test 4: Pinpointing Short Circuits on the J1939 Datalink 3. Connect the leads of a digital multimeter (DMM) to pins C and D of the 9-pin diagnostic connec- tor. See Table 1 . Set the DMM to ohms. Test 1: J1939 Resistance Test 4. Measure the resistance. The J1939 resistance test checks whether or not both terminating resistors are installed and ensures that there is at least a complete circuit from the diag- 5. After the test is complete, connect the batteries. 6. See Table 2 for test results and possible causes.
J1939 Diagnostic Connector Pinouts Pin Description Diagnostic Connector A Ground B Battery +12V D E C J1939+ C D J1939– E J1939 Shield (only if heavy cable is used) F A B F J1587+ G H J G J1587– H Not Used f151036b 05/01/2006 J Not Used NOTE: The connector is viewed looking toward the diagnostic connector. Table 1, J1939 Diagnostic Connector Pinouts Result Possible Cause Test 1: J1939 Resistance Test 60 Ω ±6 Ω The J1939 datalink backbone is intact and both terminating resistors are installed. Perform the procedures in Test 2 . Either of the following: 120 Ω ±12 Ω One of the terminating resistors is missing. One of the terminating resistors is open.
40 Ω ±4 Ω Three terminating resistors have been installed; one must be removed. There must be one termi- nating resistor at each end of the backbone for a total of two. Business Class M2 Workshop Manual, Supplement 10, September 2006 310/1