Smart Switches 54.14 General Information General Information A smart switch does not function correctly without programming the BHM. Optional features are de- signed around specific smart switch part numbers, and a different smart switch number cannot be sub- stituted. Smart switches are optional low-current switches that are connected to the Bulkhead Module (BHM) or to an optional Switch Expansion Module (SEM) on a Business Class ® M2 vehicle. A smart switch is used to activate an optional feature on the vehicle. These features may include, but are not limited to:
12 10 1 2 4 3 fog lights differential lock control interaxle lock control 4 12 pusher and tag axle controls 8 11 fifth wheel slide control f544819 PTO control Fig. 1, Connector Used on a Smart Switch split-shaft PTO and fire pump controls marker light interrupt control A smart switch is similar in appearance to a high- current switch. A smart switch can be differentiated from a high-current switch by the part number that is marked on the side of the switch. Each smart switch has a base part number of A06-37217. 9 1 2A 3 10 2B Another way to differentiate a smart switch from a high-current switch is to look at the electrical connec- tor used on the switch. See Fig. 1 and Fig.
2 for il- lustrations of the connectors used on smart switches and high-current switches. 8 6 5B 4 7 5A f544818 Fig. 2, Connector Used on a High-current Switch A smart switch is significantly different from a high- current switch. Unlike a high-current switch, the smart switch is designed to control very low currents, and will be damaged if it is connected to a high- current circuit. A smart switch has an internal printed circuit board which contains: A light-emitting diode (LED) for backlighting the switch when the headlights are turned on; A light-emitting diode (LED) that, when on solid, indicates the feature is activated and, when blinking, indicates an error condition.
Two precision resistors that are used to create a unique switch identifier that allows the BHM to identify each switch that is connected; Three precision resistors that are used to indi- cate the position of the switch. A small number of smart switches do not have an LED indicator. Instead, these switches have two LEDs for backlighting. Business Class M2 Workshop Manual, Supplement 10, September 2006 050/1 1 2 3 9 5 6 7