Freightliner — Freightliner Business Class M2 Workshop Manual

Rear and Turn Signal Lighting Systems 54.28 Exterior Lights Replacement Before working on the vehicle, park it on a level sur- face and shut down the engine. Set the parking brake and chock the front and rear tires. 5. Install the lens on the housing. Fasten it in place with capscrews. IMPORTANT: Do not overtighten the capscrews or damage to the lens may occur. Stop Light and Taillight Assembly Replacement 6. Remove the chocks from the tires. 1. Disconnect the negative leads from the batteries or, if the vehicle is equipped with a battery dis- connect switch, turn the switch to the off position. 2. Disconnect the electrical connectors to the tail- light assembly. NOTE:

There are two connectors on the left tail- light assembly and one connector on the right taillight assembly. 3. Remove the three nuts that attach the taillight assembly to the mounting bracket and remove the taillight assembly from the mounting bracket. 4. If the new taillight assembly did not come sup- plied with bulbs, follow the steps in "Stop Light and Taillight Bulb Replacement." 5. Place a new taillight assembly on the mounting bracket and secure the three nuts. 6. Connect the connectors. 7. Connect the negative leads to the batteries or, if the vehicle is equipped with a battery disconnect switch, turn the switch to the on position. 8. Verify the proper operation of the lights. 9.

Remove the chocks from the tires. Stop Light and Taillight Bulb Replacement 1. Remove the four capscrews that attach the lens to the housing. 2. Press the bulb in and turn it counterclockwise to release it from the socket. 3. To provide corrosion protection, coat the base of the new bulb with dielectric grease. For approved electrical terminal lubricants, see the applicable table in Specifications 400 . 4. Install the new bulb, pressing and turning 1/8 turn clockwise to lock it. Test the bulb for proper operation. Business Class M2 Workshop Manual, Supplement 10, September 2006 100/1