Rear and Turn Signal Lighting Systems 54.28 Separate Stop/Turn Signal Lights Conversion 14. Verify the proper operation of the lights. 6. Remove the chocks from the tires. 15. Remove the chocks from the tires. Reference Parameters for a Conversion from Combination to Separate Stop/Turn Signal Lights Converting Separate to Combination Stop/Turn Signal Lights Existing Parameter New Parameter 26-01020-000 or 26-01020- 010 26-01020-004 or 26-01020- 009 26-01020-001 26-01020-003 1. Shut down the engine, apply the parking brakes, and chock the tires. 26-01020-006 26-01020-007 2. Locate the existing turn signal wires where they terminate at the rear turn signal lights.
26-01020-012 26-01020-013 Table 1, Reference Parameters for a Conversion from Combination to Separate Stop/Turn Signal Lights 2.1 Cut the wires. 2.2 Apply heat shrink to the chassis side of the wires to seal the wire. Reference Parameters for a Conversion from Separate to Combination Stop/Turn Signal Lights 2.3 Tuck the wires in to the harness loom. Existing Parameter New Parameter 3. Locate the existing stop light wires where they terminate at the stop lights. 26-01020-004 or 26-01020- 009 26-01020-000 or 26-01020- 010 3.1 Route the wires as needed to the new combination stop/turn signal lights.
26-01020-003 26-01020-001 3.2 Use convoluted tubing to protect the wires, and use tie-straps to secure the wires to the existing harness. 26-01020-007 26-01020-006 26-01020-013 26-01020-012 26-01020-015 26-01020-014 NOTE: If the total current draw for the com- bination stop/turn signal light circuit on either side will exceed 6.7 amps, install relays. Table 2, Reference Parameters for a Conversion from Separate to Combination Stop/Turn Signal Lights IMPORTANT: When converting a vehicle from separate stop/turn signal lights to combination stop/turn signal lights, you must follow the con- version information in Table 2 exactly.
Using a different reference parameter may result in in- correct operation of either the rear lights or day- time running lights (DRL) and may have legal consequences for the vehicle owner, which may include fines and having vehicles placed out of service. The regulations in the Federal Motor Vehicle Safety Standards (FMVSS) and Cana- dian Motor Vehicle Safety Standards (CMVSS) control rear lighting and DRL functionality. Some jurisdictions enforce these regulations during vehicle inspections. 4. Using ServiceLink, apply the appropriate refer- ence parameter to the vehicle. See Table 2 . 5. Verify the correct operation of the lighting.
Business Class M2 Workshop Manual, Supplement 10, September 2006 110/2