Freightliner — Freightliner Business Class M2 Workshop Manual

Cab Air Suspension 60.14 Troubleshooting Checking the Cab Height- Control System for Air Leaks NOTE: Normal operation of the height-control valve requires a maximum of 10 minutes to settle. Any air leakage during this time is consid- ered normal and does not indicate a damaged valve. WARNING Keep your hands and all objects away from the area under and around the cab when removing the pressure from the air system. Parts will move as the air is released and can cause personal in- jury or damage to any objects that are between the moving parts. IMPORTANT: To prevent voiding the warranty on Barksdale height-control valves, note the fol- lowing: 3.

Apply a soap-and-water solution to the outside of the air fittings on the height-control valve and on the suspension air springs. Look for bubbles indi- cating an air leak. 4. If bubbles are seen, check that the air tubing is installed correctly into the fitting; see Sub- ject 100 . If no bubbles are seen, check the height-control valve for air leaks; see Subject 110 . Do not overtighten the bolts in the Barks- dale height-control valve housing if you detect leaks in the housing. The bolts should not be loose, and should not re- quire tightening. Only if necessary, tighten the valve housing bolts 45 lbf·in (500 N·cm). Any damage to the valve housing will void the warranty.

Diagnostics and Testing Air Spring Inspect the exterior surfaces of the air spring, looking for wear. With the air spring fully inflated, check to see if there is sufficient clearance around the air spring to prevent lines or objects from rubbing against the air spring. Air tubing or cab components that rub against the air spring will cause damage to the air spring. If the air spring is not capable of lifting the cab to its proper ride height, check to see if the shock absorber is damaged. A binding shock ab- sorber will limit the air spring’s ability to extend. To clean the air spring, use soap and water. NOTE:

Do not use organic solvents, abrasives, or pressurized steam cleaners to clean the air spring. If it is necessary to remove a Barksdale height-control valve from a mounting bracket, always hold the valve-side mount- ing studs in place with an Allen wrench while loosening or tightening the nuts that attach the valve to the bracket. Because the mounting studs are threaded into the valve body, loosening the nuts without holding the studs can tighten the studs, crushing the valve body and damaging the valve. Conversely, tightening the nuts with- out holding the studs can back the studs out, causing a separation of the two halves of the valve body, and possibly a leak.

Shock Absorber Inspect the shock body for damage such as bends or dents in the piston. Bends or dents in the shock body will negatively affect the operation of the shock. In- spect the shock body for signs of leaking fluid. Nor- mal operation of the shock will result in some misting of the hydraulic fluid onto the exterior shock body. Large streams of fluid indicate a leak and the shock should be replaced; see Fig. 1 . Do not attempt to disassemble the Barks- dale valve body or the control lever. There are no serviceable parts in the valve, and any disassembly will void the warranty. 1. Park the vehicle on a level surface, apply the parking brakes, and chock the tires. 2.

Run the engine to build vehicle air pressure to at least 100 psi (690 kPa). Turn off the engine and wait 5 to 10 minutes for the system to equalize. To test the operation of a shock absorber, hold the shock in an upright position and cycle the piston at least five times by pushing the piston up and down. The piston should move evenly throughout each sec- tion of the cycle. If the shock does not move evenly Business Class M2 Workshop Manual, Supplement 14, September 2008 300/1