Doors 72.00 Door Trim Panel Removal and Installation Removal 7. Pull the trim panel outward from the door to re- lease the snaps, then lift it up and over the lock knob. 1. Apply the parking brake and chock the tires. 2. Using a T40 driver, remove the two mounting screws from the upper and/or lower door-pull handle. See Fig. 1 . Installation 1. Slide the trim panel over the door-lock knob. 2. Position the trim panel in place against the door, then press firmly at the location of each snap-in fastener to ensure that it engages completely. 3. Using a T20 driver, install the two screws in the forward flange of the trim panel. 4.
Using a T20 driver, install the four screws and the lower view-window trim ring. 5. Using a T40 driver, install the upper and/or lower door-pull handle. Tighten the screws 11 to 13 lbf·ft (14 to 18 N·m). 6. Install the interior release handle. Tighten the screw 50 to 70 lbf·in (600 to 800 N·cm). 7. If the vehicle has manual-crank windows, install the window-regulator handle. 1. Window Seal 2. Door Pull Handle 3. Interior Release Handle 4. View Window 5. Door Trim Panel Fig. 1, Cab Door Trim 3. For vehicles with manual-crank windows, remove the window-regulator handle. 4. Using a T20 driver, remove the four attaching screws and the lower view-window trim ring, if so equipped. 5.
Using a T40 driver, remove the interior release handle. 6. Using a T20 driver, remove the two screws from the forward flange. Business Class M2 Workshop Manual, Supplement 21, March 2012 100/1 1 2 5 3 4 06/03/2003 f720483