Freightliner — Freightliner Business Class M2 Workshop Manual

Doors 72.00 Door Adjustment General Information A newly installed door assembly must be adjusted for correct up-and-down, fore-and-aft, and in-and-out positioning relative to the door opening frame. The door assembly should also be adjusted whenever one or more of the following conditions exist (provid- ing the door seal is correctly installed and is in good condition): wind or water leaks at the door opening frame premature wear of the door seal hard closing or opening of the door The cab portion of the hinge has oversized holes, so that when the capscrews that attach the hinge to the cab ( Fig.

1 ) are loosened, the door can be adjusted forward or aft, and up and down within the door opening frame. Slotted holes on the door portion of the hinge ( Fig. 2 ) allow for in and out adjustment of the front of the door, and mounting slots for the striker ( Fig. 3 ) allow for in and out adjustment of the rear of the door. Up-and-Down, Fore-and-Aft Adjustment 1. Apply the parking brakes and chock the tires. 02/21/2003 f720445 2. From outside the cab, check the alignment of the door with the cab door-opening frame. Check that the spaces around the top of the door are uniform. If adjustment is needed, follow the steps below. 1. Adjusting Capscrews Fig.

1, Fore-and-Aft and Up-and-Down Adjusting Capscrews on the Cab 8. Without disturbing the positions of the hinges or striker, carefully open and support the door, then tighten the hinge capscrews 11 to 13 lbf·ft (14 to 18 N·m). 3. Remove the cowl side panel. 4. Mark both the vertical and horizontal positions of the latch striker and the hinge before loosening them for adjustment. 9. Open the door and securely tighten the striker. From outside the cab, partially close the door until the latch jaws are about 1 to 2 inches (25 to 50 mm) from the striker. Be sure the striker is horizontal, and centered in the latch jaw when the door is closed. If needed, reposition the striker. 5.

Loosen the striker, then tighten it just enough to prevent unintentional movement. 6. Loosen the capscrews that attach the hinges to the cab, but keep them tight enough to prevent unintentional movement. See Fig. 1 . 7. Carefully close the door, then raise or lower it until the gap across the top of the door is about 5/16 inch (8 mm), and the gaps at the front and rear vertical edges of the door are about 3/8 inch (9 mm). 10. Tighten the striker screws 11 to 13 lbf·ft (14 to 18 N·m), then close the door and recheck the door alignment. 11. Install the cowl side panel. Business Class M2 Workshop Manual, Supplement 21, March 2012 160/1 1 1