Electric Wipers, Trico 82.00 Unitizing Tube Replacement Replacement 15. Attach the seals and connecting arms to the pivot levers. 1. Turn off the engine, apply the parking brakes, and chock the rear tires. 16. Connect the wiring harness to the wiper motor. 17. Using fasteners, attach the unitizing tube to the cab. 2. Make sure the wiper blades are parked. If neces- sary, park them by turning the wipers on and then off. 18. Attach the wiper arms to the wiper pivot shafts. 19. Connect the batteries. WARNING 20. Lower the hood. Disconnect the batteries before working on the wiper assembly. This will prevent the windshield wiper motor from cycling.
The motor could cycle if the wiper linkage driveshaft is forced out of the parked position, which could result in personal injury. 21. Remove the chocks from the tires. 3. Disconnect the batteries. 4. Open the hood. NOTE: The wiper arms are different lengths. Note which wiper arm belongs on the right and left sides. 5. Remove the wiper arms and washer hoses. 6. Remove the fasteners that attach the unitizing tube to the cab. See Fig. 1 . 7. Disconnect the wiring harness from the wiper motor. 8. Remove the unitizing tube. 9. Remove the nut and lockwasher that attach the motor lever to the wiper motor. Remove the mo- tor lever. 10. Remove the seals and connecting arms from the pivot levers. 11.
Remove the capscrews that attach the wiper mo- tor to the wiper motor bracket. Remove the wiper motor. 12. Using capscrews, attach the wiper motor to the wiper motor bracket on the new unitizing tube. 13. Using a nut and lockwasher, attach the motor lever to the wiper motor. Torque the nut 9 to 12 lbf·ft (12 to 16 N·m). 14. Inspect the seals for wear and damage. Replace if necessary. Business Class M2 Workshop Manual, Supplement 0, January 2002 100/1