Cab Heater and Air Conditioner, Valeo 83.00 Evaporator Replacement Replacement 1. Turn off the engine, apply the brakes, and chock the tires. 2. Open the hood. 3. Recover the refrigerant from the air conditioning system. For instructions, see Subject 220 . 4. Remove the air cleaner. For instructions, see Section 09.01 , Subject 110. 5. Remove the surge tank. For instructions, see Section 20.01 , Subject 130. 6. Remove the capscrew that attaches the refriger- ant lines to the expansion valve and remove the refrigerant lines. Quickly cap the refrigerant lines. 1. Evaporator Probe Wiring Harness 2. Evaporator Probe 3. Evaporator Service Cover IMPORTANT:
Under no circumstances should the refrigerant lines remain uncapped for longer than five minutes. Water and dirt can damage the refrigerant system. Do not blow shop air through refrigerant lines since shop air is wet (humid). Fig. 1, Evaporator Probe and Service Cover 17. Install the evaporator in the HVAC assembly. 18. Uncap the refrigerant lines. 19. Using only Mini Stat-O-Seals, replace the Mini Stat-O-Seals on the refrigerant lines. Do not lu- bricate the Mini Stat-O-Seals prior to installation. 7. Remove the capscrews that attach the expansion valve to the evaporator lines. 8. Remove the lower HVAC cover inside the cab. For instructions, see Group 60 . 20.
Connect the refrigerant lines to the expansion valve. Torque the capscrew on the retaining plate 11 to 15 lbf·ft (15 to 20 N·m). 9. Rotate the evaporator probe counterclockwise and pull the evaporator probe out of the evapora- tor service cover. See Fig. 1 . 21. Remove the condensate seal from the lower por- tion of the evaporator service cover, and install a new condensate seal in the same location on the service cover. See Fig. 2 . 10. Remove the capscrews that attach the evapora- tor service cover to the HVAC assembly. Remove the evaporator service cover. 22. Using capscrews, attach the evaporator service cover to the HVAC assembly. 11. Remove the filter and the evaporator. 12.
Remove the expansion valve from the evapora- tor. If a tapped hole that is used to mount the evapo- rator service cover to the HVAC assembly be- comes stripped, drill a new hole in one of the alternative mounting locations on the HVAC as- sembly. Use a 1/4-inch (6-mm) drill bit to make a new tapped hole. See Fig. 3 . 13. Make sure the new evaporator is covered with the evaporator liner and the evaporator grommet is installed on the evaporator. 14. Uncap the evaporator lines. 23. Install the evaporator probe in the evaporator service cover. 15. Using only Mini Stat-O-Seals, replace the Mini Stat-O-Seals on the evaporator lines. Do not lu- bricate the Mini Stat-O-Seals prior to installation.
24. Attach the lower HVAC cover to the dash panel. For instructions, see Group 60 . 16. Using capscrews, install the expansion valve on the evaporator lines. Torque the capscrews 35 lbf·in (395 N·cm). 25. Install the surge tank. For instructions, see Sec- tion 20.01 , Subject 130. Business Class M2 Workshop Manual, Supplement 6, September 2004 120/1 1 2 3 12/02/2003 f543876