Freightliner — Freightliner Business Class M2 Workshop Manual

Cab Heater and Air Conditioner, Valeo 83.00 Condenser Removal and Installation Removal 6. Add refrigerant oil to the compressor to replace that which is lost in the old condenser. For in- structions, see Section 83.01 , Subject 130. 1. Turn off the engine, apply the parking brakes, and chock the tires. 7. Return the hood to the operating position. 2. Remove the capscrews that attach the grille to the hood. Remove the grille. 8. Using capscrews, attach the grille to the hood. 3. Open the hood. 9. Remove the chocks from the tires. 4. Recover the refrigerant from the air conditioning system. For instructions, see Subject 220 . 5. Disconnect the refrigerant lines from the con- denser.

Quickly cap the condenser inlet and out- let ports if the condenser will be reinstalled and cap the refrigerant lines. IMPORTANT: Under no circumstances should the refrigerant lines remain uncapped for longer than five minutes. Water and dirt can damage the refrigerant system. Do not blow shop air through refrigerant lines since shop air is wet (humid). 6. If the condenser is mounted below the charge air cooler, remove the charge air cooler. For instruc- tions, see Section 09.02 , Subject 100. 7. Remove the fasteners that attach the condenser to the charge air cooler or to the mounting brack- ets. Remove the condenser. Installation 1.

Using fasteners, install the condenser on the charge air cooler or the mounting brackets. In- stall and tighten the fasteners 84 to 108 lbf·in (950 to 1220 N·cm). 2. Uncap the inlet and outlet ports on the con- denser and uncap the refrigerant lines. 3. Using only Mini Stat-O-Seals, replace the Mini Stat-O-Seals on the refrigerant lines. Do not lu- bricate Mini Stat-O-Seals prior to installation. 4. Connect the refrigerant lines to the condenser. Torque the bolt on the retaining plate 11 to 15 lbf·ft (15 to 20 N·m). 5. Evacuate and charge the air conditioning system with refrigerant. For instructions, see Sub- ject 220 of this section.

Business Class M2 Workshop Manual, Supplement 0, January 2002 200/1