Hood 88.00 Hood Repair fiberglass roller, press the cloth down firmly into the layer of adhesive to completely saturate the glass fibers. 17. Apply another layer of adhesive over the glass cloth. Spread the adhesive evenly using the fi- berglass roller. 18. After 2 to 5 minutes, the adhesive will start to jell. It may take more time when cool, less when warm. IMPORTANT: To avoid pre-jelling or skin-over, the FRP parts to be bonded should be mated within 1 to 4 minutes after the adhesive is dis- pensed. NOTE: To get a smoother surface, press a piece of masking tape, wider than the repair, directly over the wet adhesive and smooth it before it hardens.
The tape can be removed after 5 min- utes when the adhesive has set. 19. The patch should be hard enough in 50 minutes to allow sanding to a smooth flat surface, if de- sired. 20. Repair the damage on the outside surface of the hood and paint the surface on both sides, using the instructions in "Surface Damage Repair." Business Class M2 Workshop Manual, Supplement 0, September 200 2 140/7