Freightliner — Freightliner Business Class M2 Workshop Manual

TwinFlow Fire Pump 90.00 Impeller Assembly Removal and Installation Removal 11. Remove the remaining capscrews from the lower half of the AutoLube, the rear bearing housing, and the lower pump body. NOTE: For an exploded view of the fire pump body assembly, see Fig. 1 . WARNING 1. Park the vehicle on a level surface. Shut down the engine. Set the parking brake and chock the front and rear tires. The impeller assembly is heavy. Do not attempt to lift the assembly without the aid of another person or persons, or a lifting device. Failure to do so could result in the impeller assembly fall- ing, which could result in personal injury or prop- erty damage. 2. Drain the water from the pump.

WARNING The gearbox assembly is heavy. Support the lower gearbox assembly with a lifting device. Failure to do so could result in the assembly fall- ing, which could result in personal injury or prop- erty damage. 12. Remove the remaining screws from the rear bearing housing, then from the lower pump body. 13. Lift the impeller assembly from the lower pump housing. See Fig. 2 . Set the assembly aside. 3. Remove the gearbox. See Subject 110 for in- structions. 14. Clean all gasket surfaces of the upper and lower pump bodies, as well as those on the AutoLube and the rear bearing housing face. 4. Remove the drain lines from the lower pump body. 15.

Clean the clearance ring and clearance ring seats in both the upper and lower pump body halves to remove all the "build up" material so that the new clearance ring will seat properly. 5. Drain the oil from the AutoLube, and remove the 1/2–13 x 2 capscrews from the upper half of the AutoLube and pump body. NOTE: Pitting of the clearance rings may occur from the "build up" material and the effects of corrosion. Once the seats are cleaned, any pit- ting on the clearance rings is considered nor- mal. 6. Remove the 7/16–14 x 1-1/2 capscrews from the upper half of the rear bearing housing and pump body. 7. Remove the 1/2–13 x 1-1/4 capscrews from the lower pump body. WARNING Installation 1.

Install the pump body gaskets on the lower pump body, trimming as necessary to fit. The lower pump body is heavy. Support the lower pump body and impeller assembly with a lifting device. Failure to do so could result in the lower pump body and impeller assembly falling, which could result in personal injury or property dam- age. CAUTION Failure to line up the clearance ring lock notches with the pump body tabs (as described in the next step) may result in pinched clearance rings, which could result in pump damage and pump failure. 8. Position the lifting device with the lower pump body lifting adapter between the lifting device and the lower pump body. 9.

Remove the 5/8–11 x 5 capscrews in each cor- ner of the lower pump body. 2. Install the impeller assembly into the lower pump housing, carefully aligning the clearance ring lock-notch with the clearance ring lock tabs in the lower pump body. Then rotate the clearance rings to one side to open up lock notches to line 10. Lower the lower pump body and impeller assem- bly. Be sure to balance the assembly so that it does not tip from the lifting device. Business Class M2 Workshop Manual, Supplement 8, September 2005 130/1