daewoo Solar 420LC-V, Solar 470LC-V — Daewoo S0101000.FM — user manual

Return to Master Table of Contents 3. Pre-lubricate O-rings and seals before reassembly (Figure 27). 4. Before starting to rebuild piston assembly, heat slipper seal for 5 minutes in an oil bath warmed to 150° - 180°C (302° - 356°F). Use special slipper seal jig (third item in list of specialized tools at the beginning of this procedure) to attach seal. Cool seal by pushing a retracting jig against seal for several minutes. Apply a strip of clean, see-through sealing tape around slipper seal to keep it free of dust. Figure 27 Figure 28 5. Immobilize piston rod on solid support blocks. Assemble O-ring (20) and backup ring (21). Prepare to attach rod cover assembly to piston rod.

Push rod cover by tightening piston nut (22). Figure 29 S0705000 Page 17 Cylinders