DISASSEMBLY 1. The area where the motor is going to be rebuilt should be well lighted, clean and protected from dust and/or wind gusts that could carry grit or dust. Use a rubber mat or other protective overlay on workbench area to prevent damaging or scratching any precision machined components. IMPORTANT Clean all of the exterior surfaces of the motor before disassembly. There should not be any visible dirt, grease, or other type of accumulation on the outside of the casing. Clean off or blow dry all traces of cleaner or solvent before starting work and cap off or use other types of protective seals, plugs or wrapping on temporarily disconnected hoses, piping or ports. 2.
Open drain plug and drain all oil from motor casing. NOTE: Swing Motor component parts (numbered in parentheses) are keyed to Figure 4. IMPORTANT Use a clean, dry container to catch gear oil. A clean container allows an evaluation to be made of the used oil. The presence or lack of metal wear shavings in the used oil or obvious deterioration or contamination of the oil can provide a useful indicator of the motor’s general condition. NOTE: Used oil is an environmental contaminant and should be disposed of promptly at approved recycling facilities. Prolonged physical contact with used oil has been thought by some to pose a health risk.
Clean oil residue from hands and clothing promptly, and don’t allow used oil containers to accumulate. Figure 6 3. After oil has been drained completely, motor should be positioned so that exposed end of drive shaft faces downwards. Figure 7 S0707260 Page 12 Swing Motor