8. Loosen and remove all four socket head bolts (401) and separate upper valve casing (303) from lower casing (301). NOTE: Valve plate (131) inside upper valve casing (303) must be separated from assembly but take extra care to make sure that it is not scratched or damaged by an accidental fall, after cover is removed. Figure 12 9. Remove all twenty brake springs. NOTE: If brake springs are to be reused and not replaced, check and record spring free height. If a test stand is available, check height of all twenty springs under consistent loading. Replace all springs that show excessive variation or weakness. 10.
Disassemble brake piston assembly using special tool and corresponding piston bolt hole. NOTE: Figure 13 See "Special Tools" portion of this section for manufacturing details of special tool. Figure 14 S0707260 Page 14 Swing Motor