HYDRAULIC MOTOR OPERATION 1. Hydraulic Motor operation. Figure 2 The high pressure oil from the hydraulic pump goes to the cylinder block (104) through the rear flange (101) of the motor and the brake valve device and the timing plate (109). This high pressure oil acts only on the single side of the line Y1-Y2 which connects the bottom dead center and the top dead center of the piston (105) stroke. The oil, after flowing into the side of the cylinder block (104), exerts force on each piston (4 or S pieces) and generates force F (p kg/ cm x A cm ). The force F is exerted on the swash plate (103):
as the swash plate (103) is tilted with respect to the driving shaft (102) by a degrees, the force F is divided into two resultant forces F2 and F3. Among these forces, radial force F3 develops torque T (F3 x ri) with respect to each Yl-Y2 line. The combined torque T(Z(F3 x ri)), which is a rotation force, rotates the cylinder block through pistons (105). The cylinder block is coupled with the driving shaft by a spline, and the driving torque is transferred to the shaft. 2 S0707365 Page 4 Travel Motor (With Gearbox) (A6V160HD)