B. When Stopping by Deceleration. Figure 4 If the pressure oil supplied by the port A is cut off during drive. there will be no hydraulic force. Then, the spool (126) returns to the right (neutral position) through the stopper (125) by the spring (128). The hydraulic oil in chamber b goes through passage a into port A, and back pressure, which is generated by throttling of passage a controls the return speed of spool (126). At the same time, the hydraulic motor rotates by inertia force even without the pressure oil. So the return oil from port D returns to port B through a gap between the spool hole and the rear flange.
If the spool returns to the neutral position, hydraulic motor stops because all passages are closed completely. Like this, the spool’s returning speed controls the return oil from motor gradually according to the spool’s shape, and stops the hydraulic motor. As the hydraulic motor rotates because of inertia force, it tries to absorb the hydraulic oil. But hydraulic oil cannot be supplied because the oil is blocked. So the hydraulic motor will be damaged by cavitation. But, at the same time, the pressure at port D rises because the return oil from the hydraulic motor is closed. By this pressure, the spool (137) slides to the left, the ports D, C are connected.
And, by this, cavitation and pressure rising is prevented. (Function of the surge cut valve and anti-cavitation valve) The valve (127) is operated by a little secondary pressure, opens the oil passage between the port A and the motor suction part, and it prevents the hydraulic motor from cavitation. S0707365 Page 6 Travel Motor (With Gearbox) (A6V160HD)